How to Set Up FlexiPRINT RIP Software on the Peregrine DTF Printer
A full video walkthrough of installing and configuring FlexiPRINT RIP software for your Peregrine DTF printer.
This article walks through installing and setting up FlexiPRINT RIP software for use with the Peregrine DTF printer. The complete setup process is covered step by step in the video below.
Before You Begin
Have the following ready before starting the video:
- Peregrine DTF printer installed, powered on, and connected to your PC
- Printer control software installed and communicating with the printer
- FlexiPRINT installer and license information provided by Printomize America
- Windows PC with administrator access
Video Walkthrough
Tips for a Smooth Setup
- Watch the full video once before starting, then follow along and pause as needed.
- Complete each step in the order shown. Skipping steps can prevent FlexiPRINT from outputting correctly to the printer.
- Close other programs during installation.
Need Help?
If you run into issues during setup, contact Printomize America Technical Support at support@printomizeamerica.com. Include your printer model and a screenshot of any error message you receive.